High-Performance Ignition Coil Wire – Fits Denago MX Pit Bike

Upgrade or replace your existing ignition system with our High-Performance Ignition Coil Wire, specifically engineered to fit the Denago MX Pit Bike. As item #2 in the Denago MX parts schematic, this premium-grade coil wire ensures reliable spark delivery, optimized combustion, and superior throttle response for your off-road machine.

Crafted for durability and performance, this ignition coil wire features high-conductivity copper core wiring with enhanced insulation, delivering consistent high-voltage output from the ignition coil to the spark plug. Whether you're trail riding, racing on the dirt track, or tearing through rugged terrain, this coil wire ensures a powerful, clean spark every time.

The Denago MX Pit Bike Coil Wire is heat-resistant, vibration-proof, and built to OEM specifications for a perfect fit and easy installation. It’s designed to endure the high-revving nature and heat exposure common to pit bikes, ensuring long-term reliability and reduced misfires.

Whether you’re maintaining your bike or performing a performance-focused ignition system upgrade, this is a critical component that ensures top-level engine operation. Don’t let a weak spark hold you back—ignite your ride with confidence.

? Installation Instructions:

Installing the Coil Wire for the Denago MX Pit Bike is straightforward and can be done with minimal tools in under 10 minutes. Here's how:

? Tools You’ll Need:

• Phillips or flathead screwdriver (depending on coil mount screws)

• Socket wrench set

• Dielectric grease (recommended for connection points)

?️ Installation Steps:

1. Turn Off the Engine: Make sure the bike is completely off and the ignition is switched to the OFF position.

2. Access the Ignition Coil: Locate the ignition coil assembly (refer to your Denago MX pit bike parts schematic – this is item #2).

3. Disconnect Old Coil Wire:

   • Gently pull off the coil wire boot from the spark plug.

   • Disconnect the other end from the ignition coil unit.

4. Prepare the New Coil Wire:

   • Inspect for any shipping bends or kinks.

   • Apply a small amount of dielectric grease inside the boot (optional, but recommended for water resistance and a better seal).

5. Install the New Wire:

   • Push one end firmly onto the ignition coil terminal.

   • Route the wire neatly and connect the other end securely to the spark plug.

6. Test the Connection: Start the engine and observe for steady idle and consistent rev response.